16-channel Gigabit Ethernet LAN protection, PTF-616R-PRO/PoE
- Add feedback:
- Code: PTF-616R-PRO/PoE
- Manufacturer's code: 5904041752216
- Weight: 1.4 kg
-
Availability:
Produkt available
(shipping withing 24-48h)
Surge protection for gigabit network, 16-channel with RJ-45 sockets, protection for 1GB Gigabit Ethernet LAN ports, dedicated for installation of category 6, 1000Base-T and 1000Base-TX, PTF-616R-PRO/PoE
16-channel surge protection for Gigabit Ethernet networks, based on structured cabling of category 5, 5e, 6, and 6a. It is built with four PTF-64-PRO modules mounted on the PTU/PTF-6-RACK base. It is installed in a 19" Rack cabinet on the front rail, allowing for easy switching of cables in user networks or on the rear rail using angled LK-MOUNT brackets, in the case of use with IP-CCTV recorders.
The front RJ-45 sockets (DEVICE) serve as the protected side and are connected to the LAN switch ports. The sockets located at the back serve as the unprotected side (LINE), to which long lines of LAN infrastructure are connected. When using PTF series protection, an additional patch connection panel with RJ-45 sockets is usually used. In order to ensure continuous shielding of FTP cables, shielded patch cords should be used. The placement of the sockets on the unprotected side at the back of the protection is determined by the need to ensure high quality transmission parameters and low crosstalk.
The PTF-64 series modules are devices of very high surge and transmission quality. The use of multi-layer PCBs has resulted in compliance with the category 6 cabling standard and successful tests for frequencies of 4 x 250MHz.
Independent PoE protection protects against voltage surges between pairs 1,2 - 3,6 and 4,5 - 7,8. This protects LAN end device power supplies from damage caused by surges, such as lightning strikes or uncontrolled voltage increases, for example due to a PoE power supply failure. The solutions used protect all types of PoE power and allow power transmission in the Hi PoE standard.
Proper grounding of surge protection must be ensured by connecting the included grounding wire to a properly grounded rack cabinet. The optional PTU/PTF-5/6-COVER cover provides protection for circuits and protection connectors against dust, and also serves as an additional shield against interference when there are a large number of panels.
The best level of protection is achieved by using surge protection on both sides of the wires: Multi-channel on the LAN switch side and single on the end device side, for example PTF-61-PRO/PoE.
The product is tested according to categories D1, C2, C1, B2. It is intended for use at the boundaries of LPZ0/LPZ1 zones or higher.
Example of a complete Gigabit Ethernet network security
Technical specification
PARAMETER NAME |
VALUE |
Data line | |
---|---|
Number of LAN channels |
16 |
Expandability | - |
Supported Ethernet standards |
10Base-T, 100Base-T, 1000Base-T, 1000Base-Tx |
Compatibility with cabling | Cat. 6 |
Used with cabling | FTP, UTP of any category |
Input connector (unprotected side) | Shielded RJ-45 socket |
Output connector (protected side) | Shielded RJ-45 socket |
Number of protection levels |
2 (GDT, TVS) |
Rated DC voltage (line-ground) UN | 90V DC |
Maximum continuous operating voltage (line-ground) UC | 110V DC |
C1: Protection level 1kV/μs (line-ground) UP | 600V |
C2: Discharge current (8/20µs, line-ground) lmax / wire |
2.5kA (max) |
D1: Maximum lightning current (10/350µs, line-ground) Iimp |
1kA |
Rated DC voltage (line-line) UN | 3.3V DC |
Maximum continuous operating voltage (line-line) UC | 3.5V DC |
B2: Protection level 1kV/μs (line-line) UP |
20V |
C1: Discharge current (8/20µs, line-line) Iimp | 100A |
Decoupling element | Surge resistor |
Protected lines | 1-2, 3-6, 4-5, 7-8 |
Capacitance (line-line) @1MHz | 6-15pF |
Capacity (line-ground) @1MHz | 1-2pF |
Series resistance | 2.2Ω / line |
Nominal current IN | 300mA / line |
PoE Line | |
Nominal DC voltage (line-line) UN | 57V DC |
Maximum continuous operating voltage (line-line) UC | 64V DC |
B2: Protection level 1kV/μs (line-line) UP | 93V DC |
C1: Discharge current (8/20µs, line-line) Iimp | 100A |
Protected lines (pairs) |
(1+2)-(3+6), (4+5)-(7+8) |
PoE work standard | Compatible with all types including Hi PoE |
Common features | |
Dimensions | 480 x 41 x 130 (mm) |
Application | Protection of devices installed inside / outside |
Mounting method | Mounting in a 19" RACK cabinet, 1U height |
Grounding method | Wire |
Enclosure tightness | - |
Operating temperature | -40ºF~60ºF |