Ground loop separator, UTP Video balun, cctv protector, LSO-8/LST-8-FPS

16-channel combined CCTV patchpanel, for coaxial and twisted pair, UTP video balun, surge protector, Groung loop optical separator, for cctv, Ewimar, LSO8/LST8R, exquality, patch-panel, cctv, Ewimar, LSO8/LST8R-FPS, exquality, patchpanel, LSO, LST
LSO-8/LST-8R-FPS is connection of two kinds of devices, made up 8-channel passive UTP converter integrated with groung loop separator and 8-channel ground loop Video separator for coaxial cable with suppression filter. It is product such as panel mounted in RACK 19" cabinet. It is designed to change Video signal from UTP twisted pair to coaxial cable and protection of CCTV devices form effects of surges and potential differences.
It includes inside several functional blocks, to help to do installations of cables to DVRs or matrix switchers.


UTP converter for coaxial cable – changes symmetric Video signal from impedance of twisted pair (100 Ohm) to signal of coaxial cable (75 Ohm).

Gland suppression - It effectively eliminates interference between cameras, which come from power supply sources from different phases.

3-stage surge protection - It protect cameras, DVR’s and other CCTV devices from lightnings, electrostatic overvoltages and use a stun guns. 3-stage of surge suppression to level of 4 kV and pulse power supply to 10000A , efficiently boil down it to safety level for CCTV devices.

High-frequency filter - corrects the high-frequency, compensates attenuation in cables. As a result the Video quality as higher in areas of sharp edges and color quality as higher.

Convenient clamps of coaxial cable – Low-loss screw terminals for coaxial cable significantly accelerate the connection, allow easy to change configuration without need to crimping BNC connector.

Ground loop separation – eliminates distorted of Video, which are resulting of alignment potential difference on Video cables. Protect device such as cameras and DVRs from damage as a result of ground loop surges. Amorphous core introduces negligible signal losses and harmonic distortion, which always appear in optical separators known from antenna devices.

System of permanent mounting a cables – Specially constructed bracket with holes is used to permanent mounting the cables by clamp and protect from pulling, even by using large force.
 
Precision BNC connectors – Signal transmission is done by using precision BNC connectors, which are performed by CNC method.

Bidirectional action – The signal is transmitted at any directions, allowing to expand the installation options on the transmission or reception.
 
Easier installation in Rack cabinet - Suitably shaped holes simplifies installation for front of RACK cabinet. After applying LKT-MOUNT set the panel can be mounting on back of cabinet at 45 degrees, allowing to very comfortable laying cables in back of cabinet, where they are always available for installer and patch cord cables can be directly connected to CCTV devices.

Full compatibility – Panels of LSO/LST series are fully compatibility with surge protectors of LKT, LKO and SUG series, produced by Ewimar company


To obtain full protection form surges is required connection ground.
Technical Specifications:
Video channels
 8 for coaxial cable
8 for UTP twisted pair (built-in converter)
Method of attachment Rack 19" cabinet
Impedance for coaxial cable 75 Ohm
Impedance for UTP twisted pair 100 Ohm
Maximum cable length 300m for color video signal, 500m for black-white video signal
Frequency range 20Hz~10MHz
Separation 600V (minimum)
Insulation resistance 100MOhm
Attenuation 0.5dB
Stages of surge protection PCB electrodes, gas tube, transient diode
Discharge voltage 75V, Transil 8,2V
Discharge current 2 x 10kA, Transil: 57A
Capacity protection circuit No more than 50pF
Power supply channels
 16