8-channel LAN Gigabit Ethernet protection, PTU-68R-PRO/PoE
- Add feedback:
- Code: PTU-68R-PRO/PoE
- Manufacturer's code: 5904041752247
- Weight: 1.2 kg
-
Availability:
Produkt available
(shipping withing 24-48h)
Securing LAN network to gigabit network, 8-channel RJ-45 sockets, LAN network security 1GB Gigabit Ethernet, patch panel for 6th category installation, 1000Base-T and 1000Base-TX, PTU-68R-PRO/PoE
8-channel protection for Gigabit Ethernet networks, based on category 5, 5e, 6, and 6a cables. It is built with two PTU-64-PRO modules, mounted in a PTU/PTF-6-RACK housing. It is designed to be installed in a 19" Rack cabinet on the front rail for standard use, or on the rear rail using angled LK-MOUNT brackets for use with IP-CCTV recorders - many IP recorders have a built-in switch with ports on the back.
The front RJ-45 sockets (DEVICE) serve as the protected side against surges and are connected to the Gigabit Ethernet LAN switch ports using patch cords. The rear LSA connectors serve as the unprotected side (LINE), to which long lines of LAN network infrastructure are connected without using RJ-45 connectors. This solution creates two devices in one: a patch panel for terminating transmission lines and effective surge protection. This simplifies installation and reduces the number of additional elements, resulting in cost savings. To ensure continuity of the FTP cable shield, shielded patch cords should be used and metal clamps equipped with electronic plates should be used.
The PTU-64-PRO series modules are devices of very high quality for surge and transmission protection. The use of multilayer PCB boards has resulted in compliance with the category 6 cabling standard and successful tests for frequencies of 4 x 250MHz.
The independent PoE protection circuit protects against voltage surges between pairs 1,2 - 3,6 and 4,5 - 7,8. This protects LAN end device power supplies from damage caused by surges, such as those caused by lightning strikes or uncontrolled voltage increases, for example when a PoE power supply is damaged. The solutions used protect all types of PoE power supplies and allow for power transmission in the Hi PoE standard.
The protection panel has additional space for mounting 2 PTF-64 or PTU-64 series modules, which allows for expansion to a maximum of 16 channels at any time. Proper grounding of the LAN protection must be ensured by connecting the included cable to a properly grounded rack. The optional PTU/PTF-5/6-COVER cover provides protection for circuits and protection connectors against dust, and also serves as additional protection against interference when there are a large number of panels.
The best level of protection is achieved by using security measures on both sides of the cables: Multi-channel on the LAN switch side and single on the end devices side, for example PTF-61-PRO/PoE.
Product tested according to categories D1, C2, C1, B2. It is intended for use at the boundaries of LPZ0/LPZ1 zones or higher.
Example of Gigabit Ethernet protection installation using PTU-68 as a patch panel
Technical specification
PARAMETER NAME |
VALUE |
Data line | |
---|---|
Number of LAN channels |
8 |
Expandability |
Up to 16 channels |
Supported Ethernet standards |
10Base-T, 100Base-T, 1000Base-T, 1000Base-Tx |
Compatibility with cabling | Cat. 6 |
Used with cabling |
FTP, UTP of any category |
Input connector (unprotected side) | LSA (Krone) connector + shield |
Output connector (protected side) | Shielded RJ-45 socket |
Number of protective stages |
2 (GDT, TVS) |
Rated DC voltage (line-ground) UN | 90V DC |
Maximum continuous operating voltage (line-ground) UC | 110V DC |
C1: Protection level 1kV/μs (line-ground) UP | 600V |
C2: Discharge current (8/20µs, line-ground) lmax / wire |
2.5kA (max) |
D1: Maximum lightning current (10/350µs, line-ground) Iimp |
1kA |
Rated DC voltage (line-line) UN | 3.3V DC |
Maximum continuous operating voltage (line-line) UC | 3.5V DC |
B2: Protection level 1kV/μs (line-line) UP |
20V |
C1: Discharge current (8/20µs, line-line) Iimp | 100A |
Decoupling element | Surge resistor |
Protected lines | 1-2, 3-6, 4-5, 7-8 |
Capacitance (line-line) @1MHz | 6-15pF |
Capacitance (line-ground) @1MHz | 1-2pF |
Series resistance | 2.2Ω / line |
Rated current IN | 300mA / line |
PoE Line | |
Rated DC voltage (line-line) UN | 57V DC |
Maximum continuous operating voltage (line-line) UC | 64V DC |
B2: Protection level 1kV/μs (line-line) UP | 93V DC |
C1: Discharge current (8/20µs, line-line) Iimp |
100A |
Protected lines (pairs) |
(1+2)-(3+6), (4+5)-(7+8) |
PoE operating standard | Compatible with all types including Hi PoE |
Common Features | |
Dimensions | 480 x 41 x 130 (mm) |
Application | Protection of devices installed inside / outside |
Mounting method | Mounting in 19" RACK cabinet, 1U height |
Grounding method | Cable |
Housing tightness |
- |
Operating temperature | -40ºC~60ºC |