PTZ protocol converter Geutebrück to Pelco

The converter is a microprocessor device designed to control Speed Dome cameras with Pelco-D or Pelco-P protocol using the MBeg keyboard from Geutebrück company. It is installed between the control device and the rotating cameras. When installed in the middle of the distance between the camera and the controller, it doubles the length of the bus. It supports cameras by executing variable or constant speed commands with programmable speed.

It uses typical Speed Dome camera functions such as Call / Set Preset, Auto-Pan, Auto-Scan, Pattern, and also allows for calling any preset using the Aux X and Aux Y functions.

The modern processor with efficient software ensures fast data processing and very quick response to control. It has one input port for Geutebrück protocol and two independently configurable ports for cameras with Pelco protocol - individually set protocol and adjustable transmission speed in the range of 1200baud to 115200baud.

This is a product from the 3 series, fully configurable and updated via USB using the Ewimar Upgrader/Configurator software. This allows for the purchase and change of software, making it possible for the converter to be reused in other systems at a low cost. It also has additional software options that provide advanced real-time translation capabilities - activated through license codes.

Main features:

• Support for 16 cameras through one converter with individually selected addresses for each camera, ranging from 1-255.
• Possibility to increase the number of supported cameras by the converter to 99, through the purchase of additional licenses.
• Address Shift option, changing input addresses to any output addresses in the range of 1-255 - optional license.
• Support for camera numbers 1-999 after activating the Address Shift option.
• Advanced Joystick Correction option for each camera - optional license.
• Simultaneous processing of multiple motion commands: Pan, Tilt, Zoom, Iris, Focus.
• Support for programming and calling PRESET, SCAN, and PATTERN functions.
• Wide range of transmission speeds and selection of Pelco protocol type.
• Defining settings and updating software via USB port and Ewimar Firmware Upgrader/Configurator software.
• Possibility to change the software to another one when the converter will no longer be used in the existing system - software cost only.

Specification

Product safety information Manufacturer information