4-channel LAN patch-panel with surge protection and PoE

4-channel protector module for UTP with PoE

Product discontinued - has been replaced by PTU-54-ECO/PoE
 
PTU-4-ECO / PoE is an 4-channel device combining Ethernet patch-panel for UTP Category 5 and surge protection, saving your LAN network from lightning.


Patch-panel housing has a special holes and tabs for restraining wire LAN using band clips. Further holes allow the use of double bands for each LAN band clips, which increases the mechanical strength.

 
4-channel protector module for UTP with PoE

  • 4-channel IP Video protection
  • 4-channel PoE line protection (30W at 48V)
  • PoE working standard with IEEE 802.3af of type B
  • 2 degrees of surge protection (magneto Ionized + transil)
  • Compliance with UTP installations 5th category
  • Precise Krone slots
  • Recommended for installations where IP cameras are installed inside buildings

 

 
The protection consists in elimination electrostatic pulses, resulting in relation to ground (air ionizer) and pulse induced between pairs of UTP wires.
These pulses have a destructive effect on the Ethernet interface drivers, despite the use of galvanic insulation used on the hardware layer.


PTU-4-ECO / PoE is specially designed for powering CCTV from PoE switches. For powering 4,5 and 7,8 pins, which are connected together in order to increase the current flowing through the protection system. Due to the limited power decoupling resistors, the maximum power to the equipment should not exceed 15W at 48V. Decoupling resistors protect the safety components from damage in the event of an overvoltage for a longer time and allow for gradation of security.

To achieve the full effectiveness of the device it must be connected to ground (meeting the requirements of the current legislation) or PE wire of electrical system. It is not recommended to connect the ground wire to the lightning protection unit building.



ethernet surge protector PTU-16R-eco-poe
Simplified block diagram

 

Specifications:

PARAMETER NAME VALUE
Data line
Number of channels 4
Category 100Base-T(100Mbit) network,
using 5/5e/6 category twisted-pair
Levels of protection 2 (air ionizing, protection transil)
Capacity line to line 6-8pF @ 0V, 1Mhz
Capacity line to ground < 1pF
Protection level line to line 6V-1kV, 20V @ 100A , 8/20uS Vc
Maximum Uc voltage 6,8V
Maximum power 8 / 20us (line to line)
 2kW
PoE line
Number of channels 4
Levels of protection 2 (air ionizing, transil)
Protection level line to line for PoE 10/1000uS 600W / 100A. 10/1000uS
Maximum Uc voltage for PoE 58V
Protection level line to ground 90V-4kV, 2~4kA, 8/20uS
Maximum voltage line to ground 90VDC
PoE work standard Complies with IEEE 802.3af of type B
Common features
Input connector (line) Krone
Output connector RJ-45
Output ground Yes - for magnetos ionizing
Fixing Rack 19" 1U, wall
Additional options Interchangeable modules of different types, the protective cover
Dimensions 480 x 41 x 130 (mm)
Operating temperature -30~+60°C

Prohibition of copying and duplication of content! This content is reserved exclusively for the use of Ewimar company. If you want to put a product on your website, please contact our Sales Department to obtain the general-accessible contents.