16-channel LAN patch-panel with surge protection and PoE

Surge protection for IP CCTV, dedicated to power cameras in the system Power Over Ethernet. Protection of IP cameras and digital video recorders NVR, PTU-8R-ECO, PoE, PTU, Ewimar, exquality.

Product discontinued - has been replaced by PTU-516R-ECO / PoE
 
PTU-16R-ECO / PoE is an 16-channel device combining Ethernet patch-panel for UTP Category 5 and surge protection, saving your LAN network from lightning. The system is based on a 4-channel interchangeable modules, which freely chosen can create a device most suitable for the requirements of each installation.

In the described model, four modules are mounted PTU-4R-ECO modules.
Patch-panel housing has a special holes and tabs for restraining wire LAN using band clips. Further holes allow the use band clips for each LAN band clips, which increases the mechanical strength
.



ECO series is recommended for the CCTV installations where network equipment (cameras, recorders, switches), located inside the building. If you want to protect external cameras mounted on poles or roofs, use the control panel or the Pro or Extreme series.


Zabezpieczenie przepięciowe do sieci LAN
patchpanel z funkcja poe.png
 
The protection consists in elimination electrostatic pulses, resulting in relation to ground (air ionizer) and pulse induced between pairs of UTP wires.
These pulses have a destructive effect on the Ethernet interface drivers, despite the use of galvanic insulation used on the hardware layer
.



PTU-16R-ECO / PoE is specially designed for powering CCTV from PoE switches. For powering 4,5 and 7,8 pins, which are connected together in order to increase the current flowing through the protection system. Due to the limited power decoupling resistors, the maximum power to the equipment should not exceed 30W at 48V. Decoupling resistors protect the safety components from damage in the event of an overvoltage for a longer time and allow for gradation of security.

To achieve the full effectiveness of the device it must be connected to ground (meeting the requirements of the current legislation) or PE wire of electrical system. It is not recommended to connect the ground wire to the lightning protection unit building.



ethernet surge protector PTU-16R-eco-poe
Simplified block diagram

 

Specifications:

PARAMETER NAME VALUE
Data line
Number of channels 16
Category 100Base-T(100Mbit) network,
using 5/5e/6 category twisted-pair
Levels of protection 2 (air ionizing, protection transil)
Capacity line to line 6-8pF @ 0V, 1Mhz
Capacity line to ground < 1pF
Protection level line to line 6V-1kV, 20V @ 100A , 8/20uS Vc
Maximum Uc voltage 6,8V
Maximum power 8 / 20us (line to line)
2kW
PoE line
Number of channels 16
Levels of protection 2 (air ionizing, transil)
Protection level line to line for PoE 10/1000uS 600W / 100A. 10/1000uS
Maximum Uc voltage for PoE 58V
Protection level line to ground 90V-4kV, 2~4kA, 8/20uS
Maximum voltage line to ground 90VDC
PoE work standard Complies with IEEE 802.3af of type B
Common features
Input connector (line) Krone
Output connector RJ-45
Output ground Yes - for magnetos ionizing
Fixing Rack 19" 1U, wall
Additional options Interchangeable modules of different types, the protective cover
Dimensions 480 x 41 x 130 (mm)
Operating temperature -30~+60°C

 Prohibition of copying and duplication of content! This content is reserved exclusively for the use of Ewimar company. If you want to put a product on your website, please contact our Sales Department to obtain the general-accessible contents.